I assume that you want to connect the ASA5505 behind the W20 Ericsson. That is, the outside interface of the ASA will be connected to the LAN interface of the W20. The factory default settings for ASA5505 are the following: If this is the case, then the factory default configuration of your ASA will not work. An inside VLAN 1 interface that includes the Ethernet 0/1 through 0/7 switch ports.An outside VLAN 2 interface that includes the Ethernet 0/0 switch port.VLAN 2 derives its IP address using DHCP (from the ISP). The default route is also derived from DHCP.#Cisco asa activation key gui software#.A user in another forum reported that they were able to accomplish this successfully. If you do not have such a key on-hand, you will need to contact the Cisco License Team. Thus, if you wish to revert, you must overwrite the current permanent key with another permanent key with fewer features. If you enter a new permanent key, it overwrites the already installed one. You can install one permanent key, and multiple time-based keys. If you enter a key for the first time, and specify deactivate, then the key is installed on the ASA in an inactive state.
To deactivate any active time-based key, enter the deactivate keyword. The last time-based key that you activate for a given feature is the active one. If you do not enter any value, activate is the default. The activate and deactivate keywords are available for time-based keys only. The permanent key must be replaced with another permanent key with fewer features. You can only deactivate Time-Based Keys as per the Cisco Documentation.
0 kommentar(er)
